8 800 100 09 35
Feedback
Mobile laboratory of non-destructive testing KAMAZ 43118

Mobile laboratory of non-destructive testing KAMAZ 43118

The catalog contains special equipment produced by the PROMAVTO factory.
You can specify the price of a ready-made solution that is most suitable for your purposes.

Description and equipment

Appointment of van: for transporting personnel to places of research on the pipeline route, processing research results and developing images in the field at ambient temperatures from -50 ° C to + 50 ° C.
Complectation: C3-Максимальная
Production time: 2 months

Internal equipment:

  1. Additional battery block (12 V, 190 Ah) (2 pcs.)
  2. The generator.
    Model: "Vepr ADP 6.0-230 VL-BS" (fuel: diesel, power:
    6 kW, voltage: 230 V)
    1. Drying cabinet for radiograms, radiographs and X-ray films
    1. Automatic developing machine. Model: Optimax 2010 NDT
    1. Chemical laboratory sink (material of the working surface and sinks: polypropylene, case material: moisture resistant laminated particleboard)
  1. Electrical wiring with power distribution board, external input shield and 220 V sockets
  2. Sealed box with a rubber seal for the additional battery block, made of steel with a powder-coated polymer of gray color
  1. The flexible cartridge with a film 60х300
    (12 pcs.). Placed in a cabinet for equipment
  2. Set “Radiation Hazard”
    (6 racks, 6 signs, a protective tape 1000 m, fasteners, cover). Is placed
    in the equipment cabinet
  1. Negatoscope LED high brightness. Model:" NS 85x400 SD. "Located in a cabinet for equipment
  2. Voltage converter. Model: "MAP 24-220 V 6 kW". Fits in a locker
  3. Disc cutter. Model: Dahle 552. Placed in a cabinet for equipment
  1. A wall box over the operator’s desk, material: chipboard
  1. Operator's desk
  1. Two-tier sleeping shelf
    (bottom - in the form of a locker with three-point seat belts, the top when folded performs the function of a back), upholstery: gray leather substitute
  1. Wardrobe, material: chipboard
  1. The desktop of the radiologist
  2. Car seat
    with three-point seat belts (2 pcs.)
  1. Cabinet for equipment,
    material: chipboard
  2. Kitchen furniture set: wall and floor cabinets, sink, pump station for supplying water from the tank to the sinks, stainless steel water tank (volume: 100 l), boiler (volume: 30 l) in a wall cabinet, set of cookware for induction cooker, car refrigerator (model: Waeco CoolMatic CR-80), two-burner induction hob (model: GORENJE IT310AC)
  1. Car air conditioning (2 pcs.)
  1. Autonomous heater.
    Model: Webasto Airtop Evo 5500 (fuel type: diesel, heating capacity: 1.5-5 kW, fuel consumption: 0.18-0.6 l / h)
  1. Partition with a sliding door separating the laboratory and household compartments of the van
  1. Fire extinguisher OP-5
  1. Intercom between the living and laboratory compartments of the van and the cabin
  1. Towing cable (load capacity: 25 t). Placed in a cabinet for equipment

External equipment

  1. Splashers made of gray polymer powder coated steel
  2. SWH (spare wheel holder) on the rear wall of the van with a hydraulic drive for lifting and lowering
  3. Hatch with access from outside the van
    for refueling a water tank
  4. Container partition for transportation of the container
    with isotopes with a hatch outside the van
  1. Headlight finder with remote control (2 pcs.)
  2. Flashing light on the roof of the cab
  1. A partition for placing a power station on a roll-out platform and with a hatch outside the van
  1. Fiberglass emergency ventilation hatch
    with fixation in the open position and thermal insulation
  1. Wheel chocks, fixed under the van

Accessories

  • Dimensions of the van (LxWxH): 6200x2500x2200 mm;
  • Car alarm for opening the doors of the van and cab;
  • Reinforced side panels: with a step of 600 mm, sandwich panels contain cross-pieces of plywood 18 mm thick, between which heat-insulating material is placed;
  • The inner lining of the van: 1.15 mm fiberglass-reinforced plastic gray metallic;
  • Access to the van: stainless steel extension gangway,
    in transport position, mounted on the rear door of the van;
  • One and a half -wing swing doors with an opening angle of the left wing - 180 °, right wing - 100 °
    and fixation in the open position;
  • Windows in a double-glazed rubber seal:
    on the left side of the van – folding, size 800 * 570 mm
    (2 pcs.);
    on the right side of the van – folding, size 800 * 570 mm
    (1 PC.).

Our partners and clients